On 31.03.21, the serial production of a frying "Pan from a disc" (30 cm) was started

On 31.03.21, the serial production of a frying pan made of a disc (30 cm) was started, hereinafter referred to as "Frying pan".
Before we mastered this product, there was only one type of "Frying pan" on the market - welded, in which the collar is welded to the base. The welded "Skovoroda", in turn, is divided into two types:
1. "Frying pan" in which the collar is welded to the base with several points, due to which the oil flows out and ignites the fire.

We invite you to read the buyer's review, a screenshot and a link are attached:

https://rozetka.com.ua/94356428/p94356428/comments/

2. "Frying pan" in which the collar is welded to the base with a continuous seam. The method is more expensive, this method is made by more responsible and conscientious manufacturers. The method is time consuming and requires attention in order not to miss the gap.
Most manufacturers of "Skovoroda" declare the thickness of the metal 4 mm, but it is not possible to check the thickness of the base of the "Skovoroda" without the presence of special tools. We conducted an experiment - ordered a "Skovoroda" Ø 30 cm with a lid. The supplier declared the thickness of the "Skovoroda" metal - 4 mm, lids - 1.5 mm.

The result of the experiment!

Collar thickness:

Cover thickness:

Bottom thickness:

Weight measurement:

This is the total weight of a frying pan with a lid, legs, handles and a spatula!

Although only the weight of the lid and frying pan should exceed 4 kg, based on the stated thicknesses!
Making sure that we were being deceived, we refused the order!

To check the thickness of the metal, we suggest using the table of the dependence of the product weight on the product diameter and metal thickness.


The weight of the "Frying pan", without legs and without a lid with a metal thickness of 4 mm, should be:

THE SIZE	WEIGHT
30 cm	3,2 kg
40 cm	5,2 kg
50 cm	7,7 kg

Weight of 1.5 mm metal cover:

THE SIZE	WEIGHT
30 cm	0.86 kg
40 cm	1.5 kg
50 cm	2.36 kg

Our table, with the help of scales, will allow you to verify the conformity or non-compliance of the declared thickness with the actual one.
Why is metal thickness important? Because, a high-quality fire pan must be heavy (thick metal).
It does not deform from the high temperature of the fire and retains heat on the table for a long time.

Our "Frying pan" is made from a single piece using a hood!

Whereby:
1. Even theoretically, there can be no gaps between the board and the base!
2. With the help of a vernier caliper (ruler), you can easily make sure that the declared thickness of the metal is consistent (with the scales, of course, too)!
3. And the most important thing from the point of view of the buyer is the PRICE. Our "Skovoroda" is cheaper than everyone else on the market, since our technology has eliminated the need for welding, an expensive and responsible process.